[3 deaf airBridge units]
*snip*
I know I have asked this in the past but I can't be the only one to run into this.
I have seen this on a single airPoint. It is one of those weird things - it seems to work ok as an access point at our office, but does not see any access points under site survey when set to client bridge mode.
I have not had time to test the unit properly, so it can also be a config or firmware problem.
On a different note, I have never seen an airPoint hang or freeze. If there are no external problems like unstable AC power or multipath/ interference, they seem to keep on running.
I have had a couple of airPointPro Outdoors freeze, but those were the same units that got ethernet burnout a week later - most likely bad AC power or static in the ethernet cable.
-- LarsG
The PART-15.ORG smartBridges Discussion List
To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname>
To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges)
Archives: http://198.63.203.6
