RE: [smartBridges] Problem with APPO as client and Intel Pro/Wireless 2011bAccess Point

[Seeni]

Hi George, Please make sure that Intel 2011b does support address-4 field. In order to use our devices in repeater mode and CB mode, the primary AP must support "address 4" field in IEEE 802.11b specifications. When you use APPO in Client bridge mode(CB mode), please ensure that the primary port(Advanced TAB) set to WIRELESS. The primary port is actually referring to the gateway of the network.   Thanks   Seeni,  SB support   -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of George Philippopoulos Sent: Wednesday, June 25, 2003 8:06 PM To: =SMTP:[EMAIL PROTECTED] Subject: [smartBridges] Problem with APPO as client and Intel Pro/Wireless 2011bAccess Point   Hello everyone.   We are facing the following problem:   We use an airPoint Pro outdoor (Firmware 1.4j.6) as a client and we are trying to connect to an Intel Pro/Wireless 2011b Access Point (with an outdoor antenna).   Although we associate with the AP (RSSI 80% -Signal 75-80%) we cannot ping the machines attached to the AP neither the AP.   All the network settings are correct (All the devices are on the same subnet).   Has anyone faced the same problem?     Regards,   George Philippopoulos     ********************* LAMOS LTD. 24 Kipselis Str. Athens 113 62 Greece Tel.: +30210 82 56 216~9 Fax: +30210 82 17 260 http://www.lamos.com *********************