To all who has encountered troubles with our devices lately and we are all on top it and are investigating on it. But at this time we do not know what's going on with your bad units. But pls give us some times and rest assured we will update as soon as we know the root cause.
Again, we seek your understanding on this and appreciate your support. We continue to improve our product quality to make our product more reliable. Alex sB Tech Support -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Ray Sent: Wednesday, July 02, 2003 12:03 AM To: '[EMAIL PROTECTED]' Subject: Re: [smartBridges] Horror Story? Read this (not for the faint of heart) Ouch!! We too have had a APPO (client bridge Backhaul) die. As soon as I get some bench time, I plan on messing with it to see if I can make it "hear" again. SB should start looking at recent changes that may have been made such as: Firmware (repeater mode) Hardware (indoor units now have different temp ratings) Other (changes to keep outdoor firmware from loading on indoor products?) As a side note, I took the "guts" out of a indoor airpoint and replaced the "guts" from a dead outdoor APP and it's been working great! ----- Original Message ----- From: "Sam" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, July 01, 2003 9:25 AM Subject: [smartBridges] Horror Story? Read this (not for the faint of heart) > (Ok, this isn't about a Total, but you'll get the idea.) > > Three weeks ago I replaced my 5.8 ghz backhaul with two APPOs. One at > the water tower (WT) set to Client Bridge mode, and one at the NOC > (NOC) set as an Access Point. > > This worked well for three weeks - as good as or maybe better than the > more-expensive 5.8 YDI radios. Then on Saturday, the one at the NOC > stopped working. I reset it a few times, and that worked. > > My link stayed up for 16 hours. > > Sunday the link went down again. This time the one at the WT was the > culprit. It had a link light, but I could not log into it. I plugged > my laptop directly into it, reset the power shot numerous times, used > different power shots, tried straight through and crossover, searched > for the APPO, entered the ip address manually, all to no avail. So up > the tower I go, 150 feet, (this after just having knee surgery) and > replaced the radio. All came up and worked fine. > > For 18 hours. > > Then the APPO on top of the WT failed again. (This is the second, > brand new APPO unit, in two days.) The link light was out, and woud > not come on no matter how much resetting, powering off/on I would do. > > So I took my last spare (again a brand new APPO, as if that means > anything > anymore) back up the WT, 150 feet, bad knees and all, and replaced the one > that worked for 18 hours. The link came back up. > > I'm crossing my fingers, praying to God, knocking on wood, and doing > everything I can to hope this one will stay up until I can get EC to > send me three replacements for these three APPOs I've replaced in > three days. (Side note: I'm glad that ElectroComm has been so good to > work with as they have been, or I'd be back to just being a dialup > ISP, being an embarrasing failure in trying to offer broadband using > Smartbridges > infrastructure.) > > To make matters worse, this all happened two days after signing a > contract with the county for $1500.00 for a year for my wireless > service. I fully expect them to call me tomorrow and tell me to stick > that contract in my ass, thanks to these APPO units that were > apparently assembled and/or QA'd by Larry, Moe and Curly, if at all. > > I have an AP on top of the same water tower, an OLD APPO, made back > before it seems that Smartbridges decided to be all things to everyone > and add in every new feature that was mentioned, running from the same > UPS and mounted on the same mast as the one I have changed three times > in as many days. This OLD APPO is having no problem at all. I have > another OLD APPO in a different location that is an AP that hasn't > been reset since October 2002. Again, I refer you to the downhill > slide in the QA department. These old units are working like a champ. > The new stuff coming out of Singapore leaves a lot to be desired. It's > not unrealistic to expect to be able to get more than 24 hours of > service out of an APPO before having to replace it. And again, this > wasn't an isolated incident - it was three brand new units in three > days. > > If this last APPO that I put up there fails before December and it's > not due to a lightning strike or rifle shot, I plan to begin the > process of exchanging all of my Smartbridges equipment with Cisco, or > whatever solution will put stability ahead of experimentation. Being > new to this, I don't know if all manufacturers have this same problem > or not. Maybe I'm setting my expectations too high, and the all have > problems like this. Has anyone had any good experiences with Cisco, > Alverion, Telex, or any of the other vendors? I would really like to > stay with Smartbridges, but not if this level of quality (or lack > thereof) persists much longer. > > (And this is all in addition to six of 10 Airbridge indoor units I > have to return from this last shipment as well for various > reasons...won't associate, won't come on, power light comes on but > nothing else, ethernet light comes on and goes back off intermittently > with a known good cable, ESSID turning to garbage, ad nauseum....but > the backhaul (APPOs) have been my main focus right now as they are > taking my entire wireless network down when they have their daily > failures.) > > Sam Morris, Owner > Loganet Internet Service > Logan IA > > PS: It would be way-cool if the plant in Singapore would send me three > APPO units made from the most-recent batch that hopefully have all of > the problems fixed. Given the embarassment and serious financial > impact my company has suffered and continues to suffer from my loyalty > to and the failure of the units shipped from Smartbridges right after > the production plants cranked back up, this doesn't seem like a lot to > ask. I already know I'm losing the $1500.00 contract with the > courthouse. As soon as the phone company starts up DSL next week I > expect to lose several more customers, and I can't really blame them, > given that these APPOs have forced them back to dialup so frequently. > If Smartbridges is willing to do so, my address is: > > Loganet > 2607 220th St > Logan IA USA > 51546 > > Phone number is 712-644-3578 if you need it. > > If you can send me three that will work for a reasonable period of > time I'll even pay you for them, but as things stand right now, I've > more than paid for the lack of quality of your products in lost and > frustrated customers, severe damage to my company's reputation, and a > general feeling that I have been royally taken in by a company I had > counted on. I just hope mine can survive through all of this. > > The PART-15.ORG smartBridges Discussion List > To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> > To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) > Archives: http://archives.part-15.org > The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
