Title: RE: [smartBridges] URGENT: Head-End APPO not receiving a thing!!

This sounds like a either an APPO death but I doubt it but I believe it might be a dead AMP is there an inline amp?

-----Original Message-----
From: The Wirefree Network [mailto:[EMAIL PROTECTED]]
Sent: Thursday, July 17, 2003 3:49 PM
To: [EMAIL PROTECTED]

Thanks for the tips everyone!!

I used a unit here with a YAGI antenna and was able to associate and log
into my repeater.  All of my clients are still associated with the
repeater, but none with the headend.  Under the "site survey" tab, I
chose the "choose from available AP's", and I am able to SEE (hear) the
head-end aPPo transmitting.  But...it still is NOT receiving a single
thing.

I am just about to replace the antenna and pigtail.  I just got one in
the mail, and I figure I will take this opportunity to install it.

Once I cutoff my layers of waterproofing, I will connect my new
antenna/pigtail and see if I am receiving anything.  If not, it is a
good thing that I still have one aPPo in stock.  However...it is an old
one.  CRAPOLA!! That means I have to do some inline splicing.  I hate
doing that.

It appears as though it is a failed unit due to it transmitting fine,
but not receiving a thing (after all, it uses the same pigtail and
antenna).  That should mean that the connections are good.  But I will
soon confirm.

Sully


-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]] On Behalf Of Kevin Summers
Sent: Thursday, July 17, 2003 12:26 PM
To: [EMAIL PROTECTED]
Subject: RE: [smartBridges] URGENT: Head-End APPO not receiving a
thing!!


Check any and every connection between the APPO and the antenna.
Look for loose connectors, or water, or a dead amp, etc..

If all looks good it's probably the APPO.

Kevin Summers
KISTech Internet Services Inc.
www.kistech.com
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of The Wirefree Network
Sent: Thursday, July 17, 2003 12:06 PM
To: [EMAIL PROTECTED]
Subject: [smartBridges] URGENT: Head-End APPO not receiving a thing!!
Importance: High


My new head-end aPPo just went down.  I have had it online for about 5
days
now with no problems.  I am logged into it and looking at the
statistics, it
is receiving ZERO packets.  It is constantly transmitting beacons.but is
receiving NOTHING.  I have reset it.factory defaulted it.turned off
WEP.turned off authentication.etc.etc.NADA..no received packets at all.

I have about 22 units that are normally associated to this head-end (one
of
which is a repeater with 20 more clients behind it).  Everyone is
down!!!

Has the unit gone to crap or am I forgetting to check something key??

Thanks all!

Sully



The PART-15.ORG smartBridges Discussion List
To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe
smartBridges <yournickname>
To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe
smartBridges)
Archives: http://archives.part-15.org 

The PART-15.ORG smartBridges Discussion List
To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname>
To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges)
Archives: http://archives.part-15.org 

Reply via email to