How would you do it with a windows based MRTG like product I could not get the one from SB to work at all maybe its just the way I had it set up or something I gave up after 2 hours of messing with it..
----- Original Message ----- From: "shoffman" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Wednesday, August 20, 2003 9:19 AM Subject: Re: [smartBridges] MORE ABOS crapping out You can pull SNMP data from each radio.. WARNING!!! data sometimes has some real outliers!! (we had one device report it was communicating 80 Gigapackets/second on its RF port... uhmmm not likely... We just ignore ludicrous readings like that.. Scott -----Original Message----- From: "Blazen Wireless" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Date: Wed, 20 Aug 2003 09:11:36 -0700 Subject: Re: [smartBridges] MORE ABOS crapping out > probably that virus is a bitch I was up all night at my regular job > with the telco listening to the network people work on it all night. > > Here is a question can I pull SNMP info from each radio I have this > software that I think might work is there specific port that it needs > to listen to for the radio info or do I have to set it up to go > retrieve it? > > http://www.kiwisyslog.com/software_downloads.htm#syslog > > Seems like pretty cool software.. > > ----- Original Message ----- > From: The Wirefree Network > To: [EMAIL PROTECTED] > Sent: Wednesday, August 20, 2003 9:05 AM > Subject: RE: [smartBridges] MORE ABOS crapping out > > > I have yet to receive a new order of the REPLACED CHIPSET. I have > only been receiving the "DEFECTIVE" chipset plus firmware. Yes.I used > the word DEFECTIVE appropriately. > > > > sB is VERY quiet today. They must be getting hammered by all the > VIRUSES/WORMS! (-; > > > > Sully > > > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Blazen Wireless > Sent: Wednesday, August 20, 2003 8:56 AM > To: [EMAIL PROTECTED] > Subject: Re: [smartBridges] MORE ABOS crapping out > > > > thats funny I run a ping log on my system when they systems go down > it is 0930PT -1700PT about the same times you are describing? did the > firmware or chip change lower the threshold on how much heat these > things can handle?? > > > > > > ----- Original Message ----- > > From: The Wirefree Network > > To: [EMAIL PROTECTED] > > Sent: Wednesday, August 20, 2003 8:48 AM > > Subject: RE: [smartBridges] MORE ABOS crapping out > > > > I have 25 clients off of my repeater (aPPo in access point mode) > which connects back to my head-end via an indoor airPoint. My head-end > has 24 clients plus the repeater locations (2 of them) which is 26 > associated. If you include the users on the other side of the > repeaters, I have a total of 52 clients going through my head-end aPPo. > > > > Everything was fine with my head-end until I put up one of the new > (bad chipset) units. It now will drop ALL my users are random times > (normally between 10 am and 5 pm). It only gets up to 80 degrees > here.so heat shouldn't be an issue. > > > > My repeater with 25 clients on it.works flawlessly! It is an older > aPPo with the hardwired CAT5 attached. > > > > Sully > > > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Blazen Wireless > Sent: Wednesday, August 20, 2003 7:44 AM > To: [EMAIL PROTECTED] > Subject: Re: [smartBridges] MORE ABOS crapping out > > > > I notice that when I get 21-22 users and sometimes 23 is the max > that seems to be able to associate to the APPO before I start seeing > the dissociation problems. > > ----- Original Message ----- > > From: Blazen Wireless > > To: [EMAIL PROTECTED] > > Sent: Wednesday, August 20, 2003 7:32 AM > > Subject: [smartBridges] MORE ABOS crapping out > > > > Okay I give up I have 4 of the new radios I purchased with > supposedly the new chi and the new firmware and they are still > disassociating any wonderful ideas on what to try next. > > > > 1. I have tried everything I have tried in the past when this > whole thing started so PLEASE SB don't tell me stupid stuff to check > already since I know 100% it is not the installation. > > 2. When we went to look at the one yesterday it was thought to be > heat related. We touched the ABO and it was Luke warm if at hottest. > Link light (blue) was just flashing away NO association. RSSI 85% Link > 95% GREAT signal and he keeps losing associating every day. > > > > PLEASE PLEASE PLEASE let us know what's causing this. > > > > This customer is hooked from the radio to a D-link 4 port router > to his laptop as are most all my installs.. > > > > > > > > > The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
