Dan Petermann Wyoming.com
At 05:01 PM 9/3/2003 -0400, you wrote:
Dan,
Is this an Airbridge Total? -- Rudolph Worrell President Phone:(540)664-3950 Fax:(270)458-6431 www.wave2net.com
Quoting Dan Petermann <[EMAIL PROTECTED]>:
> I'm using 1 total as a back haul. It's AP is an old Aironet BR-500 used for
>
> the uplink. I've had it in this configuration for about 2 months and
> haven't had a problem with it yet. It feeds the main AP with nothing more
> than an ethernet cable in between them. From my house 4.5 miles away with
> marginal LOS I consistently get around 1200k of thruput. The uplink AP is
> fed by a single T-1.
>
> Here is a basic diagram of the setup: Aironet AP --> Total --> ethernet -->
>
> APPO.
>
> At 08:08 AM 9/3/2003 -0400, you wrote:
> >Can anyone tell me if they have used an Airbridge Total to backhaul to an
> >APPO in AP mode. I am trying to cut cost in the backhaul and just want to
> >use the bridge to AP then have the clients connect via other bridges to
> the
> >AP.
> >
> >Question 2: I am up 200 ft with a 12 Dbi Omni and can only get about 2
> >miles NLOS and about 5 LOS. Anyone gotten further?
> >
> >Question 3: Does anyone use splitters and AMPS the the AirBridge Outdoor
> >and APPO? What kind?
> >
> >Rudolph Worrell
> >President
> >Phone:(540)664-3950
> >Fax:(270)458-6431
> >www.wave2net.com
> >
> >-----Original Message-----
> >From: [EMAIL PROTECTED]
> >[mailto:[EMAIL PROTECTED] Behalf Of Jason
> >Sent: Wednesday, September 03, 2003 7:56 AM
> >To: [EMAIL PROTECTED]
> >Subject: RE: [smartBridges] Ethernet side going down
> >
> >
> >I'd say it is not new. I recently had two APPOs that started exhibiting
> >this behavior after 6 months of perfect performance. It happened after I
> >upgraded the firmware, and switched the operational modes, and
> >everything went to pot. They exhibited the same behavior you are
> >describing (except only when in access point mode - bridge or client
> >modes were fine). Also, the ethernet "went away" for only about 10
> >minutes at a time, then would reappear.
> >
> >I never got to the bottom of it - decided to stop wasting my time and
> >worked around it with other gear.
> >
> >Jason
> >
> > > -----Original Message-----
> > > From: [EMAIL PROTECTED]
> > > [mailto:[EMAIL PROTECTED] On Behalf Of D G
> > > Sent: Wednesday, September 03, 2003 7:33 AM
> > > To: [EMAIL PROTECTED]
> > > Subject: [smartBridges] Ethernet side going down
> > >
> > >
> > >
> > >
> > > Anyone notice a new issue with ethernet sides going down for
> > > no reason?
> > >
> > > Our last 2 installs are doing this. One is an ABT that the
> > > ethernet side will go away for anywhere between 20 minutes to
> > > an hour then come back up. We were running a ping test over
> > > the weekend and was what it has been doing.
> > >
> > > The other is an ABI in an outdoor enclosure. It needed a
> > > power cycle yesterday morning to bring it back and it looks
> > > like it's been down for about 6 hours now. Probably need to
> > > do a power cycle to bring it back up in the morning. I'm
> > > pinging the radio side right now so I know it is powered up
> > > but I can't get to the box behind it.
> > >
> > > Both installs are under a week old. Both units were upgraded
> > > to .7 The ABT has been around the office for a couple of
> > > weeks and the ABI came in and went out last week.
> > >
> > >
> > > Don Grossman
> > > www.willitsonline.com
> > > icq# 4224548
> > >
> > > ----------ANNOUNCEMENT----------
> > > Don't forget to register for WISPCON IV
> > > http://www.wispcon.info/us/wispcon-> iv/wispcon-iv.htm
> > >
> > > The
> > > PART-15.ORG smartBridges Discussion
> > > List
> > > To Join: mailto:[EMAIL PROTECTED] (in the body type
> > > subscribe smartBridges <yournickname> To Remove:
> >mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges)
> >Archives: http://archives.part-15.org
> >
> >----------ANNOUNCEMENT----------
> >Don't forget to register for WISPCON IV
> >http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm
> >
> >The PART-15.ORG smartBridges Discussion List
> >To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe
> >smartBridges <yournickname>
> >To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe
> >smartBridges)
> >Archives: http://archives.part-15.org
> >
> >----------ANNOUNCEMENT----------
> >Don't forget to register for WISPCON IV
> >http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm
> >
> >The PART-15.ORG smartBridges Discussion List
> >To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe
> >smartBridges <yournickname>
> >To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe
> >smartBridges)
> >Archives: http://archives.part-15.org
>
>
> ----------ANNOUNCEMENT----------
> Don't forget to register for WISPCON IV
> http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm
>
> The PART-15.ORG smartBridges Discussion List
> To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges
> <yournickname>
> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe
> smartBridges)
> Archives: http://archives.part-15.org
>
------------------------------------------------- This mail sent through IMP: http://horde.org/imp/ ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm
The PART-15.ORG smartBridges Discussion List
To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname>
To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges)
Archives: http://archives.part-15.org
----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm
The PART-15.ORG smartBridges Discussion List
To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname>
To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges)
Archives: http://archives.part-15.org
