Re: [smartBridges] Repeater, Client Bridge or 2 APP's

[John Banes]

If it works for you don't worry about it. I am using an omni and a panel on a APPi in repeater mode.   John ----- Original Message ----- From: Rudolph Worrell To: [EMAIL PROTECTED] Sent: Friday, September 12, 2003 5:54 AM Subject: RE: [smartBridges] Repeater, Client Bridge or 2 APP's I am using the splitter to repeat the signal from the main APPO.  I can't repeat just with the Omni so I am using the 24dbi grid to get the signal.    Why no omni and directional on the same radio?  I had it in a test setting and it seemed to do ok.  Let me know if I am heading in the wrong direction. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]On Behalf Of Marlon Schafer (509-982-2181) Sent: Thursday, September 11, 2003 8:26 PM To: [EMAIL PROTECTED] Subject: Re: [smartBridges] Repeater, Client Bridge or 2 APP's Why do you need a splitter with an amp?  We have many customers at around 10 miles and some as far as 16 with 8 or 9db omni antennas with 500 mw amps and NO client side amps.   Do NOT use an omni and directional antenna at the same time off one radio.....  Bad karma.   marlon   ----- Original Message ----- From: Rudolph Worrell To: [EMAIL PROTECTED] Sent: Thursday, September 11, 2003 5:53 PM Subject: RE: [smartBridges] Repeater, Client Bridge or 2 APP's I just did this today.  I installed an APPO in repeater mode about 10miles from my 200ft tower with a 24dbi antenna.  The APPO and antenna are only at bout 35ft with near LOS.  The link quality and RSSI are a little low so I am thinking of putting in an amp on the main APPO.  We are going to put up a 2way splitter with a 9dbi omni to get 360 coverage.   As for the radius of an omni, I got 10 miles with a 12 Dbi Omni.  Directional antennas are better anyway but I am just getting started and this setup works for me. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]On Behalf Of Sajeeva Salgadoe Sent: Thursday, September 11, 2003 10:14 AM To: [EMAIL PROTECTED] Subject: [smartBridges] Repeater, Client Bridge or 2 APP's Hi,    We have a small community with around 20 customers, which is located around 10 miles away from our main tower. We want to provide service to them and not sure how we can provide the service to them. We have installed APPO with 13.5db omni directional on a 120 feet tower. We can't get the LOS to the community so have to install a repeater, or Client Bridge some where between the tower and the community. We are not sure whether APPO in CB mode with omni can solve this problem. (5miles radius might be too much for omni). Best solution might be putting a APPO with 2 directional antennas( Is it possible to do this ? if  'yes' , how ?). Also we think about installing 2 APPO's and bridge them. Not sure this can be done without having any external router.   I appreciate your ideas and suggestion about this matter   Thanks Sajeeva