Set your second one to Access point mode also. All of your IP addresses should work the way you have them set up.
---------- Original Message ---------------------------------- From: "Robin McCaig" <[EMAIL PROTECTED]> Reply-To: [EMAIL PROTECTED] Date: Wed, 24 Sep 2003 11:47:05 -0500 >Let me run this scenario by you guys. > > > >Internet Router's Ethernet-->Switch-->[EMAIL PROTECTED] >Site-->ABO-->Hub-->APPO-->ABO > > > >If I want to allow the 2nd ABO to access the Internet through the Tower >Site, what mode will I have to set on the 2nd APPO assuming the 1st APPO >is in Access Point Mode? And will the IP addressing listed below work >for the link? > > > > > >IP addressing is as follows: > > > >Internet Router 10.10.10.1 Subnet 255.255.255.0 > >APPO @ Tower Site 10.10.10.2 Subnet 255.255.255.0 Default Gateway >10.10.10.1 > >1st ABO 10.10.10.3 Subnet 255.255.255.0 Default Gateway 10.10.10.1 > >2nd APPO 10.10.10.4 Subnet 255.255.255.0 Default Gateway 10.10.10.1 > >2nd ABO 10.10.10.5 Subnet 255.255.255.0 Default Gateway 10.10.10.1 > > > >Im not sure about the Gateway addresses for everything on the backside >of the first APPO, and will I have to enable non IP traffic in order to >use the same gateway? > > > >Thanks, >Robin > > > > > ----------ANNOUNCEMENT---------- Don't forget to register for WISPCON IV http://www.wispcon.info/us/wispcon-iv/wispcon-iv.htm The PART-15.ORG smartBridges Discussion List To Join: mailto:[EMAIL PROTECTED] (in the body type subscribe smartBridges <yournickname> To Remove: mailto:[EMAIL PROTECTED] (in the body type unsubscribe smartBridges) Archives: http://archives.part-15.org
