> On Feb 29, 2016, at 5:27 PM, Robert Mustacchi <[email protected]> wrote: >> I can see all traffic just fine when I run snoop in the global zone. >> >> A possible added difficulty is that the mirror port is spitting out 802.1q >> tagged traffic. I was only getting the LLDP traffic between the switch and >> the router (i.e. untagged) before I configured the nic with a vlan in the >> smartmachine. > > When I originally did the unfiltered promisc bits it was focused on > additional mac addresses for KVM guests which would still be on the same > VLAN. There could be some gotchas there. Though, I'd also run dladm > show-linkprop to verify that it's been properly set. Note that this will > require the zone to be halted and then started up again.
Turns out that it was not being set right. I rebooted the zone, and then prior to starting tcpdump, ran: dladm set-linkprop -z 2dc24843-a10c-6e9d-a9d0-c69520ece6d9 -p promisc-filtered=off net1 I was rewarded with "dladm: warning: invalid link property 'promisc-filtered'", but the current value changed from "on" to "off", and after that tcpdump worked as expected. Doesn't seem to be persistent across reboots of the zone though. Any clues to making it persistent? -r ------------------------------------------- smartos-discuss Archives: https://www.listbox.com/member/archive/184463/=now RSS Feed: https://www.listbox.com/member/archive/rss/184463/25769125-55cfbc00 Modify Your Subscription: https://www.listbox.com/member/?member_id=25769125&id_secret=25769125-7688e9fb Powered by Listbox: http://www.listbox.com
