Hi, sorry for the confusion! Yes i send several mails, because sometimes the mail i send or receive is filtered and is not delivered. And so i don't know if it reaches the list. I still have problems with TelnetIOSPing or IOSPing. I do not insist on TelnetIOSPing or IOSPing i just want to measure connectivity between two cisco-devices or from a cisco-device to a network device. I attached the smokeping --debug output and the config file. Normally i'm a windows user, but i did not get smokeping running on windows, so i start to use a Debian3.1(German Network-install) . I installed all the other stuff with apt-get or aptitude. I never compiled any package by myself. So please be lenient. And, except Telnet/IOSPing i got everything running so far. It is an awesome tool - no questions!
Best regards, Andreas -----Ursprungliche Nachricht----- Von: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Auftrag von Niko Tyni Gesendet: Donnerstag, 27. April 2006 20:47 An: Andreas Schneider Cc: smokeping-users Betreff: [smokeping-users] Re: Smokeping IOSPing On Thu, Apr 27, 2006 at 01:40:09PM +0200, Andreas Schneider wrote: > i have IOSPing configured in my config-file. > After a "smokeping reload" i have no(!) error messages on the console and in > the syslog, > but the charts do not get filled... there is no data in the graphs. Hi, try 'smokeping --debug', and see if there's anything there that looks relevant. The IOSPing module isn't very chatty or smart. It just stuffs its IOS commands into an rsh session and hopes for the best. If it gets an rsh session going at all, the problem is probably that your IOS version doesn't accept all the commands. You'll have to look at the module source code if you want to investigate this. The TelnetIOSPing module is probably a better bet. > Btw is there a possibility to setup smokeping to generate logfiles for the > targets? As Kennedy mentioned, there's 'rawlog'. On the TelnetIOSPing front, I'm quite confused by now since you have sent several mails with different problems. If you still have some, please explain them again, send the result of 'smokeping --debug' and your full configuration file. Cheers, -- Niko Tyni [EMAIL PROTECTED] -- Unsubscribe mailto:[EMAIL PROTECTED] Help mailto:[EMAIL PROTECTED] Archive http://lists.ee.ethz.ch/smokeping-users WebAdmin http://lists.ee.ethz.ch/lsg2.cgi -- Attached file removed by Ecartis and put at URL below -- -- Type: application/octet-stream -- Size: 5k (5150 bytes) -- URL : http://lists.ee.ethz.ch/p/06-config -- Attached file removed by Ecartis and put at URL below -- -- Type: application/octet-stream -- Size: 21k (21806 bytes) -- URL : http://lists.ee.ethz.ch/p/smokeping--debug.log -- Unsubscribe mailto:[EMAIL PROTECTED] Help mailto:[EMAIL PROTECTED] Archive http://lists.ee.ethz.ch/smokeping-users WebAdmin http://lists.ee.ethz.ch/lsg2.cgi
