I guess this proves that not all Czech planes are created equal. Some are
very good and some are not so good. I have a Czech plane too. My Hades has
so far lived through lots of balistic dives, hitting the vertical enbankment
head on at Cape Blanco (don't ask) and landing in a bunch of rocks in a
later flight. The only damage from all this is a few very small dents from
the rocks.

I am very please with this Czech plane. I would also buy a Czech plane from
Dieter and Marcella of Shredair because I know I can trust them to only sell
quality planes that they stand behind. I also know that Tom Copp is carrying
the Hades and some other cool planes that are rated well.

Will I buy another Czech plane? As soon as I can afford it.

Randy Bullard


>Subject: [RCSE] test flying a new Molded Planes/Czech Republic


> I recently got a new glider from NSP, the MICRO 1.5.  it is made by KB
> Modle in Czech Republic.
> > then the landing!  i carefully landed on the thickest grass, with
> airbrake full.  it sounded like a smoothe landing.  surprisingly, i
> found one crack one inch long, and 3 holes on the wing skin.  another
> crack was produced when we were examining  by finger pressing on the
> fragile wing skin. i have never had another hollow molded plane before,
> but this is like egg shell.
> a week later, i was landing it ,the wing tip hit some grass, the plane
> spin 360 into a landing, the left wing LE is cracked.
> Sal told me the wing was Carbon but i am not sure where it is used.
> the vtail fitting fail too.  the single 1mm steel bolt stripped and the
> vtail came loss. they should really use 2 bolts.
> this glider is especially good for light wind, the fastest! and
> loudest.  but the fun is also reduced by its fragillity.
>
> Raymond Wong


RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to