I just learned the meaning of the saying that "if I didn't have bad luck I
wouldn't have any at all". I mounted the 3110 motor in my winch frame and
ran it so I could sand the shaft like you would in a lathe. I had to sand
the entire length of the shaft. The end by the brushes was harder as I had
to remove the armature and be very careful. I finally got it all done.
When I tried to mount the Real Balls to the motor, the bolts will not go
thru the slots in the heat sink. Now I have to go buy new bolts. I'm
stubborn enough to keep at it until it's done.
George Meyers WD6EQS
Fresno, California
Graduierte, schule der harten klopfen
RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
"unsubscribe" requests to [EMAIL PROTECTED] Please note that subscribe and unsubscribe
messages must be sent in text only format with MIME turned off. Email sent from web based email
such as Hotmail and AOL are generally NOT in text format
