David,
I think the ASH26 has the same system as my Alpina 4001. It has
the floating system. The joiner does not touches the fuselage. The 12
mm steel rod goes into the brass tubes in two wing halves, thru a hole
in the fuselage. The hole is about 2 mm bigger than the rod.
There are 4(2 on each side) pin that glued into the root
ribs and you have to match drill the holes in the fuselage. I
think you can find the instruction in the Tangent sailplanes. If
not I may be able to find the Alpina instruction and mail it to
you.
If you have the 12 mm rod, then everything else can be home
made.
Brian
At 3:47 PM -0700 6/12/06, David Portwood wrote:
I just purchased this, but the wing joiner system was missing, does anyone have one they no longer need or a description of it so I may make my own.
This was a 12 mm floating joiner system.
Thanks,
David
--
Brian Chan
An Electric Airplane [EMAIL PROTECTED] Mateo.Ca.USA
An Electric Airplane [EMAIL PROTECTED] Mateo.Ca.USA
