In a message dated 6/22/2006 10:45:15 A.M. Central Daylight Time, [EMAIL PROTECTED] writes:
I don't know if the servo failure is related to anything.  I don't know
what's going on at all.  Can anyone help me?  I'd like to use Goop but I
think I'm locked into using Silicone since I used it first.  Am I correct? 
Or is there a way of decontaminating the Siliconed surface?

Robert
    The servo failure could be related to the acid contained in the Silicone.  Goop does not contain acid and does not contain Silicone.  You should be able to remove the Silicone by rubbing it off after it is cured.
 
    I use Loctite 5140 for servo installations.  It is non-corrosive, translucent, self-leveling, and meets MIL-A-46146B Group I type II.  It is probably over engineered for this application, but it has worked well for many years.
 
Don Richmond
San Diego, CA (Virginia Beach, VA today)
[EMAIL PROTECTED]
www.hilaunch.com

Reply via email to