NO
Total antenna length is not important.
Why? Because most of the antenna is inside a metal casing (carbon tube/fuse) and will not work as an antenna. Best antenna length is btw around 9m for 35mhz..... so I would not care so much about the antenna length ;-)

But I agree on the loop back. There is no point in doing that.

Hilsen (Regards) Jojo
NEW: www.jojoen.no

Date: Thu, 22 Jun 2006 10:46:30 -0700
From: Martin Usher <[EMAIL PROTECTED]>
To:  [email protected]
Subject: Re: [RCSE] Re: Can one use a copper wire for an antenna
Message-ID: <[EMAIL PROTECTED]>

Don't forget to keep the total antenna length about the same as the
original receiver antenna length, don't loop back surplus wire (just
zig/zag it in the wing if its too long) and be careful of any connector
you put in the antenna lead -- unlike other connections you'll never
notice a poor contact, or even a disconnection, until too late (reduced
range).

You can use thin insulated wire, stuff like one strand of a servo cable,
and stranded is preferred over single core because its less likely to
break (its also a bit better electrically but you'd probably notice -- a
break OTOH won't show up at all except as reduced radio range).

Martin Usher

------------------------------

End of Soaring V1 #7824
***********************
RCSE-List facilities provided by Model Airplane News. Send "subscribe" and "unsubscribe" requests to [EMAIL PROTECTED] Please note that subscribe and unsubscribe messages must be sent in text only format with MIME turned off. Email sent from web based email such as Hotmail and AOL are generally NOT in text format



RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]  Please note that subscribe and unsubscribe 
messages must be sent in text only format with MIME turned off.  Email sent from web based email 
such as Hotmail and AOL are generally NOT in text format

Reply via email to