|
Hi guys,
Took a soldering gun and about 5mins to figure out and do the mod to make
the JR 10 Synth RX accept a remote button for programming.
Now I don't have to be stabbing the RX in the face at the field or fighting
with it for access.
It has 10 channels, right? A JR 9303 has 9, we only use 6 for the
most part, 7 if you have a Picolario.
I just melted the solder joint on AUX 5's signal pin and shook off the
solder acting as a jumper to the Aux5 signal land on the board. Once it was
clear, I figured out that the 'edge' side of the face button was the hot side,
the other just ground, so I ran a small wire from that edge side connection to
the AUX 5 Signal pin.
Now I can plug in one of my Polk Set Buttons and it does the same as poking
the inny button. No chopping and it would take about a minute to put it all back
just the way it was.
Totally exhausted from the effort....not.
You guys probably had it figure out though.
Gordy
|
