The most important change for the glitching at the back of the vtail was not touched by chokes and capacitors. I had also done the flaps and ailerons the same way really compounding the problem.. I was using #26 computer cable wire and using just four wires. When I used separate wires for each servo, since I did not have any larger wire with a thin enough insulation cover, the beads and capacitors could clean up the act and in fact were hardly needed. So much so that I am still looking for a good source of wire in the next two sizes commonly used 24 and 22. I should credit someone for writing a note to me about this but I have forgotten but would like to pass on their tip to me that worked. Just in case you are thinking of responding as a supplier to the preceding I am not looking for 3 feet . I think in terms of 100 500 or 1000. RCSE-List facilities provided by Model Airplane News. Send "subscribe" and "unsubscribe" requests to [EMAIL PROTECTED]
