The FMA website  http://www.fmadirect.com   is the easiest site to get to
that lists a coreless servo.  The prime difference is the quality and type
of the motor.  In addition the gear system is normally of the higher
quality.  The problem is their size.  I have not had the chance to examine
any of their coreless servos.  With there better parts being the top of the
manufacturers lines of course they will center better.  So if you were only
to buy one it might be worth it just for the elevator.

The Horizon listing of servos is much harder to get to and does not list
which ones are coreless in the list that I viewed.   Their easiest list to
read is their former "Indy" ad or catalog division of Horizon in AMA.
Unfortunately the AMA magazine is available to probably less than half the
list.  In addition they don't always include the list.

Everyone else has decided the standard case is .812 inches wide but JR is
.75 wide.  The JR will do flaps on many wings with a standard case.  The
standard case gives about twelve options of which there are several coreless
and beyond that several digital.

The coreless JR are very smooth running.  The average person will be very
surprised when they attempt to move the top of the servo and discover how
easily it turns and smoothly.  I have not had the opportunity to try the FMA
this way.

I had one friend who flew helicopter.  Basically you had to have at least
ball bearings and often beyond that coreless for the desired performance.
But when it came to contest days for other types -  he was both a very good
flyer but an excellent builder- he would use bottom of the line Jr which was
at that time the 507.  His logic-  he needed the servo to last  three trim
flights a half dozen practice flights and then three or four contest flights
then he would sell it.  He felt that would last long enough for him to do
that but it would take a little more and you could tell they were
deteriorating.

His advice on gliders was to give the elevator a blip in either the up or
down direction your choice before launching but always the same direction.
This was to test for radio on and set the  elevator to the same position
each time for launch.  This took care of many of the non centering and
similar problems that we often see.

So the coreless if you can find one that will fit in the application::
because they are ball bearing , better gears, and coreless motor would
easily outlast the common servo.  But wouldn't you expect that at 3xs the
price.  Now the question is will it improve it enough to make it worthwhile?
Or will I keep it long enough to make it worthwhile?

Rick


RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to