I just looked at my 5x and I think it must've changed.  I don't see any
trim menu and there is not save option.  Oh well.

-Ben

Nathan & Marni Woods wrote:
> 
> Re-setting your trims is a Flash (sorry).  Again, assuming programming
> didn't radically change from the 5 non-x:
> 
> 1)  Hold Top two buttons next to on/off switch.  While holding down both
> buttons, turn on power.
> 
> 2) Press top button repeatedly until you get to the Trim menu.
> 
> 3) Now use the Rudder trim tab (bottom left) to select the servo channel
> 
> 4) Now use the Aileron trim tab (bottom right) to incrementally adjust the
> trims for that channel, zero out as needed.
> 
> 5) Pressing the top button again, scroll through to the Save menu and press
> the Bottom button to confirm the Save.  It should give a signifying beep.
> 
> 6)  Turn off the power, then turn it back on without holding down any of the
> buttons.
> 
> 7)  Re-Adjust your clevis, and go fly.
> 
> Repeat as needed.
> 
> Good luck.
> 
> Nathan  Woods
> Temple Hill Slope Squadron
> Orange, California
> <mailto:[EMAIL PROTECTED]>
> 
> RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
>"unsubscribe" requests to [EMAIL PROTECTED]
RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to