That can be fixed with a 2" jumper cable one side with eye slug and other
with C clip. The C clip has inside diameter much smaller than bottom
section of telescopic, while the eye slug will be pressed contact to the
source at the mounting point inside the housing. Hope that helps. You may
us any replacement antenna of any diameter telescopic but length must be
stock compatible. Hope that help.
YK Chan
----- Original Message -----
From: Terry Throop <[EMAIL PROTECTED]>
To: [RCSE] <[EMAIL PROTECTED]>
Sent: Tuesday, June 20, 2000 9:54 PM
Subject: [RCSE] Antenna Problems on Stylus
> I have been having problems with antennas for Stylus transmitters. The
> brass insert at the bottom of the antenna breaks loose so the antenna
> won't tighten down on top of the transmitter. This is the second
> antenna in about three months that this happened to. Three questions:
>
> 1) Anybody else been having this problem?
>
> 2) Is there a loss of signal because the antenna isn't completely
> "solid?" Talking to Airtronics, they feel that this is a "problem", but
> then again at $20 per antenna I would always classify this as a
> "problem."
>
> 3) Can the antenna be soldered and be a "better" antenna?
>
> TIA
>
> Terry Throop
>
> RCSE-List facilities provided by Model Airplane News. Send "subscribe"
and "unsubscribe" requests to [EMAIL PROTECTED]
RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
"unsubscribe" requests to [EMAIL PROTECTED]
