In a message dated 7/14/2000 18:47:16 PM Central Daylight Time, [EMAIL PROTECTED] writes: > Is this confusing to you guys as well or am I just not reading > the book right. Could there be something wrong with the radio?. She has > been > in for service twice since I have had the radio. You may not be executing everything quite right. Here's my basic procedure for setting launch & reflex: 1. On the setup menu, ensure you have dual flap enables and flap control set to SW+T. 2. Program launch and reflex flap throws using the T. ADJ menu. Put the switch in the down (launch) position and adjust the travel until you get your flaps right, then put the switch in the up (reflex) position and adjust your reflex setting. The flaps should now have the right throw in each position. 3. Go to the FL-AL mixing menu. Enable the mixing by selecting the FL U+D switch option. Put the flap in the launch position, then adjust the mix % for the appropriate amount of aileron throw. Repeat for reflex. I find I often have to switch back and forth a couple of times (and the procedure is sensitive to how much aileron throw you have programmed. I found I got the best results if I adjusted aileron throw to maximum using the T ADJ menu, then enabled the differential mixer to get aileron differential, rather than setting aileron differential using T ADJ.) Hope this helps, Glenn Harker Heights, TX RCSE-List facilities provided by Model Airplane News. Send "subscribe" and "unsubscribe" requests to [EMAIL PROTECTED]
