|
Thanks to Dan I was able to change the shift on my receiver..
of course I didn't make a note of which connector went where before I remobed
the wires..
Does anyone have the channel assignments for this
Rx?
Thanks..
-- Tom
----- Original Message -----
Sent: Thursday, September 14, 2000 7:54
PM
Subject: Re: [RCSE] Berg Rx Shift
Selectable?
Tom--
Yes it is, but you have to move a soldered jumper.
I did
mine and it was very simple if you are comfortable soldering
very
small components.
With the RX pins toward you, the shift jumper is
right in
the center of the circuit board. If the jumper is across
the
center and right pin you are shifted for Futaba/Hitec.
Jumper across
center and left pin is for JR/Airtronics.
If you want I can scan and
send you the instruction sheet.
Dan
----- Original Message
-----
From: Tom Sheehy <[EMAIL PROTECTED]>
To: RCSE
<[EMAIL PROTECTED]>
Sent:
Thursday, September 14, 2000 4:43 PM
Subject: [RCSE] Berg Rx Shift
Selectable?
> Hello,
>
> Does anyone know if Berg
receivers are shift selectable?
>
> If so, how do you
convert?
>
> Thanks!
>
> -- Tom
>
>
RCSE-List facilities provided by Model Airplane News.
Send "subscribe" and
"unsubscribe" requests to
[EMAIL PROTECTED]
>
|
