I've sorta followed this discussion. I've built a Highlander, 2
actually. I used the arrow shaft for the first one. It is difficult to
get the arrow shaft for the full length of the fuse. If you do not get
the arrow shaft the full length, wherever it ends will be a hinge
point. Mine was near the point of the leading edge. After a mess of
landings, the EPP will loosen up. The tape will lose its grip. Even
minor flexing of the fuse will wiggle the tail feathers a whole lot
because of where you put the servos.
My Highlander died honorably. Folded a wing at the peak of the launch.
Came down like a lawn dart. Simply shredded.
The second Highlander was built differently. I got some 1/32" plywood
in large sheets from Aircraft Spruce
(http://www.aircraftspruce.com/main.html) for surprisingly little $$$.
I made side plates for the fuse going more or less from the nose to the
tail area. I did not cut an exact profile of the fuse as such, but
simply added a side stiffener. I glued it one with 3M spray adhesive
77.
The fuse is both stiff and tough and has lots and lots of flight time,
lots of vigorous landings, has never gotten sloppy. To me this
stiffness is important. With long fuses, any lack of stiffness in the
fuse causes all sorts of motion in the tail feathers. You add the thin
plywood and don't have to add the tape so the weight increase is
marginal.
Only way to go IMHO.
Bill
RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
"unsubscribe" requests to [EMAIL PROTECTED]