I have used the connectors from Dymond Models that have been 
mentioned and the crimper available from Radio Shack, Part number 
276-1595, $9.95.    Changed over a few servos to the new airtronics 
connector, made some aileron plug-ins.   Pretty straightforward.  No 
failures, no problems, no hex allowed for saying so.

I got the info from Rob Crockets web page, couldn't find the url, but 
here's a copy of his data:

>Use your keen powers of observation to carefully examine the black
>plastic connector shells, the silver pins, and the crimping tool.  Note
>that the female pins go into the male shells, and the male pins go in
>the female shell.  Note that the pins have a notch on one side that accepts
>the locking clip on one side of each hole in the connector shell.  Note
>one end of each pin has two sets of adjacent crimping wings, one for
>bare wire copper and one for insulated wire.  Note that each of the the
>two crimper jaws is made of two pieces of sheet metal, making the depth
>of the crimping troughs deeper on the numbers side (for the lesser
>insulation crimp), and shallower on the other side (for the tighter wire
>copper crimp).  Look carefully at the troughs and see a ridge at the
>bottom that folds the pin wings back into the wire copper or
>insulation.  Use the 28-24 slot for your regular wimpy servo wire, and
>the 24-20 slot for beefier battery wire.  Look carefully at an assembled
>servo connector to plan the wire order and the position of each pin
>notch in your final product. 
>
>Enough with research . . . time to crimp.  Strip the insulation from the
>end of each wire, just enough to have uninsulated wire in the wire
>wings, insulation in the insulation wings.  I twisted the strands of
>each wire, but others don't (the factory certainly does not).  Gently
>pinch the pin wings together slightly so that the pin will fit firmly,
>wings first, into a trough, with the wings flush on each side of the
>crimper.  Put the pin in the crimper so that the wire comes into the pin
>from the numbers (insulation) side of the crimper.  Think again about
>where the pin notches need to be for your final product.  Hold the wire
>in place in the pin with one hand, carefully eyeball the process, and
>crimp with the other hand, crimping both insulation and copper with one
>squeeze.  Once all the pins are on the two or three conductor wires,
>slide the pins into the connector shell, all at the same time to avoid
>separating the wire strands far back from the connector, until each
>shell clip clicks into each of the pin notches.  A pin or dental pick
>can help push in the pins, or release the clip if you goofed.  Triple
>check it, because you can smoke a servo if the wires are swapped.
>
>Lettuce, mustard, tomato, and a servo connector please,
>Rob Crockett
>Eureka, CA
RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to