Hello All!

No questions this time. Just a report on a fix I have
in the works for my balsa sheeted terminator wings.

As you may recall, I had problems with warped trailing
edges on the balsa sheeted wings I built, after I put
on the water-based polyurethane. I mentioned it here
on RCSE and got several suggestions to fix the
problem. I went with the boiling water over
terry-cloth towels and clamp it down solution that
fixed the warping, but unfortunately, caused the 3M77
to come unstuck on some spots. So I had fishlips on my
trailing edges.

Then I hit upon this solution that would both
straighten my trailing edges and make them stronger.
Recalling that folks with Zagis in Arizona have
troubles with 3M77 loosing adherence in 110 degree
heat, I used my heat gun to warm the trailing edges
until the 3M77 became gooey and separated the balsa
sheets to just past the foam core. Then I placed the
wing panel on waxpaper on the edge my flat/straight
workbench and inserted a length of fiberglass tape
between the balsa sheets. I epoxied the glass in,
being careful to scrape off all the excess epoxy I
could. I then clamped a steel yardstick on top of the
edge and as of now it is curing. I hope 24 hours is
enough time to let it cure before I go on to the next
panel. (I don't have enough clamps to do more than one
panel at a time.) After it cures I will trim off the
excess fiberglass tape.

So if this works as I hope, I will have both
straightened the trailing edges and strengthened them
with fiberglass. I can't wait to fly!

John Gossett
Austin, Texas

__________________________________________________
Do You Yahoo!?
Make a great connection at Yahoo! Personals.
http://personals.yahoo.com
RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to