Jeff,
Yes you can tie all the +ve and -ve wires together. This will reduce the number
of pins required to 4 per side. For my Sierra, I used MPX connectors available
from Karlton. I chose the 6 pin connectors and used all wires for each servo.
Not the lightest, but more redundant. These connectors are nice flat blade
connectors. They are actually suitable for higher power. Almost any connector
will do though for typical servos.
Since the wing is not plug in, but bolt on, it would be tough to make it
automatically plug together as you install the wing. I just left the male ends
dangle from the wing root a few inches and the female ends lying in the fuse,
hooked up to the Rx with pigtails. To put it together, you slide the wing
together with the joiner, plug the connectors together, then bolt it on,
ensuring that all your wires are in the fuse.
> Jeff F wrote:
>
> I'm building my first full-house (Arthobby Sierra 2.5M) Can any one point me
> to some tips on consolidating the 4 connectors from the wing. Can I wire all
> the + - together and seperate the four signals from each servo? Any
> suggestions on connectors?
>
> TIA
>
> Jeff F
-- James
.-------------_--.
James R. Osborn * [EMAIL PROTECTED] | \ / \ |
Up and Running LLC * http://www.upandrunningit.com |-. \ _ /\\_/ |
Computer and Information Technology Support | '-.\ / \\/ |
(510) 377-4514 Office * (510) 232-2575 Fax | ____' \_/ |
`----------------'
RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
"unsubscribe" requests to [EMAIL PROTECTED]
