Michael, See if you can get a "left hand" drill bit. They are not that hard to find (http://www.mytoolstore.com/hanson/hanson.html). You can do a internet search on them. Make sure you run you drill press in reverse. At some point while drilling into the head of the screw, it will probably catch and unwind the screw out. Be ready because you will have to quickly let up on the pressure on the handle. The drill diameter should be approximately the same as the screw diameter.
-----Original Message----- From: Michael Ackerman-Simpson [mailto:[EMAIL PROTECTED]] Sent: Monday, April 22, 2002 6:27 AM To: [EMAIL PROTECTED] Subject: Re: [RCSE] Nemesis These screw heads are recessed, and tiny, I think I'll go with the drill them out (with the drill press) idea. Thanks, Now, how bout those molded wings, any web info, or plain old info, on how to repair buckles near the tips? I think I may need to cut back the area an insert foam then glass over that, any opinions? Thanks again, Mike in Freshwater, CA RCSE-List facilities provided by Model Airplane News. Send "subscribe" and "unsubscribe" requests to [EMAIL PROTECTED] RCSE-List facilities provided by Model Airplane News. Send "subscribe" and "unsubscribe" requests to [EMAIL PROTECTED]
