Twist.
Back to back spinners with two rings between will just about eliminate the
problem.  If not find out which end of the spinners is restricting movement.
At that end put two more rings.    The rings act as the universal joint to
free up the spinners to spin.  If the spinners are too light I have heard
this can cause problems.  Further you may have to do some work on your winch
line too  with double swivels in exactly the same way.  It is assumed you
are using braided nylon or Dacron  for the retriever and braided nylon for
the winch . Twisted line simply causes too many difficulties since you are
always trying to unwind the twist

Speed
The Rahm was supposed to have used a 6volt motor.  You could sub a 12 or 24
armature cut to length to slow it down.  The cheap way out is to use a piece
of heavy coat hanger between the relay and the starter.  Protect it because
it can glow red hot but usually will perform the function well for you.  I
have also used 3/32 stainless welding rod.

Rick


Date: Thu, 4 Jul 2002 10:06:05 -0400
From: Barry Andersen <[EMAIL PROTECTED]>
To: [EMAIL PROTECTED]
Subject: Rahm retriever
Message-ID: <p05001903b94a04b832d5@[10.0.1.2]>

CSS has a Rahm retriever that doesn't get much use.  I tried somewhat
successfully to get it going.  It does, however, put a lot of twist
in the line which leads to some problems of snarls.  Swivels are in
place on the harness now.

Does anyone use a Rahm retriever successfully?  If so, what line is
in use, do you use something to work against the twist, eg. prop or
spinner, any recommended techniques?  We're running ours on a 6 volt
battery and it still goes waaaay fast.

Any help appreciated.

Barry


RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]

Reply via email to