Try a programmable mix with VrD as the master and Flp2 as the slave. Set the rate at about 15%.
JE -- Erickson Architects John R. Erickson, AIA > From: Lapo Nustrini <[EMAIL PROTECTED]> > Reply-To: Lapo Nustrini <[EMAIL PROTECTED]> > Date: Tue, 29 Oct 2002 20:19:47 -0800 > To: [EMAIL PROTECTED] > Cc: [EMAIL PROTECTED] > Subject: Re: [RCSE] How to program camber on a 9CAP Futaba? > > Hello Aireze1, > > I had the exact same problem recently (and in fact am still struggling trying > to have the flaps and ailerons move at the same rate while adjusting camber) > > There are a couple of good pages on setting up a full house glider using the > Futaba 8U transmitter, which are also quite relevant to the 9CAP. > Have a look at: > http://members.cox.net/jeffareid/futaba.htm > and > http://www.scalesoaring.com/escape.htm > > One other source of information are a couple of Yahoo groups: > > http://groups.yahoo.com/group/9CFutaba/ > and > http://groups.yahoo.com/group/futabaowners/ > > in this last one, a quick search for "camber control" will bring up a recent > thread on the subject. > > Good luck, and if you figure out how to get the ailerons and flaps to move > together, please let me know. > > > Best regards, > > Lapo Nustrini mailto:lapo@;bischeracci.com > > > Tuesday, October 29, 2002, 3:12:13 PM, Aireze1 wrote: > > Acc> Hi All, how do you go about putting a camber setting on the 9CAP? I would > Acc> like to have it on the "A" switch on the left side of the tranny. TIA, > Rich > Acc> RCSE-List facilities provided by Model Airplane News. Send "subscribe" > and "unsubscribe" requests to [EMAIL PROTECTED] Please note that > subscribe and unsubscribe messages must be > Acc> sent in text only format with MIME turned off. > > RCSE-List facilities provided by Model Airplane News. Send "subscribe" and > "unsubscribe" requests to [EMAIL PROTECTED] Please note that > subscribe and unsubscribe messages must be sent in text only format with MIME > turned off. RCSE-List facilities provided by Model Airplane News. Send "subscribe" and "unsubscribe" requests to [EMAIL PROTECTED] Please note that subscribe and unsubscribe messages must be sent in text only format with MIME turned off.
