|
Hi
Chris,
in
setmode 5 , you can change the sensibility of the interference
detection
off =
no detection, 6 highest sensibility.
with
JR-rx I normaly use setting 3.
you
can check on the ground how much your servos may jitter,
before
the
voice will tell you attention.
Thommy
Raphael
Thanks but my manual doesn't tell me what
off/1/2/3 actually does for me in this mode, can you enlighten me
??
Thanks
Chris
----- Original Message -----
Sent: Monday, July 21, 2003 8:30
AM
Subject: AW: AW: [RCSE] New USA
Picalario owners...some information
Hi
Chris,
just hold down the programming key on the picolario
while turning power on.
Picolario starts in "programming mode". Use your
3-position-switch to change
to
mode 5 (one up or five down :-))
Press the blue "programming key" to enter mode 5.
then change the value with
your 3-pos-switch. Press the blue key again to
save. turn off your picolario.
Your settings are changed now!
Yours
Raphael
So how do you set mode 5 up and how does it
actually operate?
Thanks
Chris
----- Original Message -----
Sent: Sunday, July 20, 2003 6:22
AM
Subject: Re: AW: [RCSE] New USA
Picalario owners...some information
if there is no free channel just connect it to your
receiverbatteries,
You will have variotone , altitude announcement as
preset in mode 4,
I prefer every 10 s, and voltage if it is
sinking.
But you have to set glitch warning to off (setmode5),
because there can be none
correct pulse, if it is just connected to
batteries.
It is also possible to use a 2-position switch, one
position automatic alti announcement
and the other Vario off (for acrobatics)
.
Thommy
Thanks Thommy!
Of course all I have to do for the
straight to battery connection is pull the signal wire from the Pic's
plug, and leave it in the Gear channel.
Gordy
|
