Hi, jim,
I sure your method for "spoiling" the Ava works very well, but my method is
simple, and seems to work very well.  I used a servo sixed like the Hitec
HS-77BB low profile servo lying on its side, with the mounting lugs removed,
and glued to the rib with E-600 contact cement.  I used a long arm on the
servo to press against the bottom of the spoiler to open it, and used a
torsion bar made of  K&S music wire,  .028 in diameter, I think, but just
small enough to go in a piece of K&S 1/16" diameter aluminum tube to hold
the spoiler closed.  I was going to use two, but one proved sufficient.
Barry Kennedy recommends not opening the spoiler more than 45 degrees, and I
can vouch for the fact that is good advice. I also used Hitec HS 425 BB
servos for rudder and elevator, figuring that servo power was far more
important than trying to save weight, and a 1400 mAh battery.  After several
repairs and nose ballast, mine now weighs about 43 oz,  and the more it
weighs, the better it flies!  I did omit the ballast tube, as this bird
penetrates very well without it.  I can hardly wait for my second one to
arrive!
Hope this helps Ava owners!
Dave Darling
Modesto, CA



----------------------------------------------------------------------------------
Dial Broadband has arrived in most areas! Up to 5 times faster than traditional dialup 
connections from $13.33/month! See the demo for yourself at http://www.BigValley.net

RCSE-List facilities provided by Model Airplane News.  Send "subscribe" and 
"unsubscribe" requests to [EMAIL PROTECTED]  Please note that subscribe and 
unsubscribe messages must be sent in text only format with MIME turned off.

Reply via email to