Hope one of you guys can help ... kind of stuck here. best regards ervin -------------------------------------------------- boot ---------------------------------------- comBIOS ver. 1.32i 20071005 Copyright (C) 2000-2007 Soekris Engineering.
net5501 0512 Mbyte Memory CPU Geode LX 500 Mhz Pri Mas IC25N040ATCS04-0 LBA Xlt 1024-255-63 39070 Mbyte Slot Vend Dev ClassRev Cmd Stat CL LT HT Base1 Base2 Int ------------------------------------------------------------------- 0:01:2 1022 2082 10100000 0006 0220 08 00 00 A0000000 00000000 10 0:06:0 1106 3053 02000096 0117 0210 08 40 00 0000E101 A0004000 11 0:07:0 1106 3053 02000096 0117 0210 08 40 00 0000E201 A0004100 05 0:08:0 1106 3053 02000096 0117 0210 08 40 00 0000E301 A0004200 09 0:09:0 1106 3053 02000096 0117 0210 08 40 00 0000E401 A0004300 12 0:20:0 1022 2090 06010003 0009 02A0 08 40 80 00006001 00006101 0:20:2 1022 209A 01018001 0005 02A0 08 00 00 00000000 00000000 0:21:0 1022 2094 0C031002 0006 0230 08 00 80 A0005000 00000000 15 0:21:1 1022 2095 0C032002 0006 0230 08 00 00 A0006000 00000000 15 1 Seconds to automatic boot. Press Ctrl-P for entering Monitor. GRUB Loading stage1.5. GRUB loading, please wait... Error 18 ------------------------------------------------------------------------------------------------------ The PXE boot went fine and I installed the GRUB loader on the 40GB HD as you can see above. Changes were made according to this guide https://wiki.ubuntu.com/Soekris However booting afterwards gives me the GRUB error 18 ..... it's a minimal install on a full ext3 formatted HDrive. --------------------------- The GRUB manual says: ------------------------------------------- "Selected cylinder exceeds maximum supported by BIOS. This error is returned when a read is attempted at a linear block address beyond the end of the BIOS translated area. This generally happens if your disk is larger than the BIOS can handle (512MB for (E)IDE disks on older machines or larger than 8GB in general)." ------------------------------------------------------------------------------------------------------- This is my 5501 comBios settings: ConSpeed = 9600 ConLock = Disabled ConMute = Disabled BIOSentry = Enabled PCIROMS = Enabled PXEBoot = Enabled FLASH = Secondary BootDelay = 5 FastBoot = Disabled BootPartition = Disabled BootDrive = 81 80 F0 FF ShowPCI = Enabled Reset = Hard any ideas?? _______________________________________________ Soekris-tech mailing list [email protected] http://lists.soekris.com/mailman/listinfo/soekris-tech
