Have a look page 204 and following of the SC1100 databook. There is everything you need to program it.
2007/11/22, Antoine Zen-Ruffinen <[EMAIL PROTECTED]>: > Hello, > > If you look a the net4801, it is written section 3.11: " This red LED > is connected to the SC1100 processor GPIO20, pin D21. It is connected > so that it will be on at power on,....". Then you should have a look > at the SC1100 datasheet for how to program it. > > I have programmed the GPIO of the PC87366 unsing inb and outb, it work > fine. I assume you can do the same with the GPIO of the SC1100. > > Antoine > > 2007/11/22, ajv <[EMAIL PROTECTED]>: > > Hello, > > > > I am programming the 4801 in assembler under Linux (Slax) > > Can you point me to a document or provide me with a piece of code > > written in assembler using direct port I/O (not using a kernel driver) > > to switch the error LED on and off? > > > > cat/proc/ioports shows : 6100-612B NatSemi SCx200 GPIO > > I assume I can use inb and outb into this region? > > > > Thanks in advance. > > > > _______________________________________________ > > Soekris-tech mailing list > > [email protected] > > http://lists.soekris.com/mailman/listinfo/soekris-tech > > > _______________________________________________ Soekris-tech mailing list [email protected] http://lists.soekris.com/mailman/listinfo/soekris-tech
