On Wed, 28 Nov 2007, Sam Leffler wrote:
> Bob Keyes wrote: >> Hello, >> I am building about a dozen boxes. Each will have a net4826, USB flash >> drive, SR9 and CM9. I also need space for a power connector, serial >> connector, and Ethernet. LEDs would be nice as well. >> >> I am not sure what we're going to use for RF connectors. It depends on >> what's available for rubber duckie antennas at 2.4 and .9 ghz. >> >> It would be great if these could be had with a stand, so the unit doesn't >> take much desk top. Something with a little more room in the case for >> additional sensors would be great as well. These enclosures don't have to >> be especially pretty. I'd prefer something metal but plastic is possible. >> >> Any suggestions? >> > Just a comment; I assume you've got samples but the SR9's have an extended > footprint so from the looks of the 4826 board layout they can only go in the > socket where the cpu is. That might make mechanicals and RF tricky. My only > experience building up systems with these cards is on a totally different mb. Yes, it's problematic - we've had to extend the USB headers so they don't collide with the SR9. It's a real PITA. It would be nice (hint, hint) if the headers were right-angle so oversized mini-pci cards could fit. Also, we'venoted that you can't run an SR2 and SR9 at the same time in a net4826, probably because of all the current drawn. -Bob _______________________________________________ Soekris-tech mailing list [email protected] http://lists.soekris.com/mailman/listinfo/soekris-tech
