Hi All on the list, I'm trying to get working a Lexar CF 8Gb 300x UDMA using a net5501-70. ComBIOS v1.33 reports the CF as below, but only a after issue a reboot command from the ComBIOS prompt:
Pri Mas LEXAR ATA FLASH CARD LBA Xlt 972-255-63 7815 Mbyte Below there are my settings ConSpeed = 57600 ConLock = Enabled ConMute = Enabled BIOSentry = Enabled PCIROMS = Enabled PXEBoot = Disabled FLASH = Primary BootDelay = 5 FastBoot = Disabled BootPartition = Disabled BootDrive = 80 81 F0 FF ShowPCI = Enabled Reset = Hard CpuSpeed = Default Whenever I get it to boot the kernel 2.6.26.5-28.fc8 reports the CF as scsi0 : pata_cs5536 scsi1 : pata_cs5536 ata1: PATA max UDMA/100 cmd 0x1f0 ctl 0x3f6 bmdma 0xe000 irq 14 ata2: DUMMY ata1.00: CFA: LEXAR ATA FLASH CARD, 20071016, max UDMA/100 ata1.00: 15630048 sectors, multi 0: LBA ata1.00: limited to UDMA/33 due to 40-wire cable ata1.00: configured for UDMA/33 scsi 0:0:0:0: Direct-Access ATA LEXAR ATA FLASH 2007 PQ: 0 ANSI: 5 sd 0:0:0:0: [sda] 15630048 512-byte hardware sectors (8003 MB) sd 0:0:0:0: [sda] Write Protect is off sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00 sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA sd 0:0:0:0: [sda] 15630048 512-byte hardware sectors (8003 MB) sd 0:0:0:0: [sda] Write Protect is off sd 0:0:0:0: [sda] Mode Sense: 00 3a 00 00 sd 0:0:0:0: [sda] Write cache: disabled, read cache: enabled, doesn't support DPO or FUA sda: sda1 sda2 sda3 sd 0:0:0:0: [sda] Attached SCSI removable disk So the question is does the above Lexar CF works with suck net5501-70? Does it's supported or not? Thanks in advance. Roberto Fichera. _______________________________________________ Soekris-tech mailing list [email protected] http://lists.soekris.com/mailman/listinfo/soekris-tech
