Hello world!
Am 13.01.2009 um 15:13 schrieb Richard Verwayen:
After a cold boot (systems powerless for more than 18h), only one
out of 4 network interfaces show any activity (sometimes, it is
only vr1, sometimes, it ist vr1 and vr3). No LED is flashing even
though they are connected to a working switch. pfSense recognizes
all 4 Interfaces, but I am only the one showing activity is
working.
A reboot doesn't change that behaviour, but a short power
interuption (less than 1h) does.
The via interfaces seem to be picky, try doing a ifconfig vr0 down,
or whatever the interface number is and then
ifconfig vr0 up.
Doesn't change the situation at all.
I do have the same symptom when no OS is booted and I am in the BIOS-
setup....
I got a replacement board and it shows nearly the same error again,
but now only vr3 is affected.
I tried to document the behaviour at http://jxim.de/soekris/
Could it be something similar to
http://www.soekris.com/issue0005.htm ?
Best regards!
Richard
P.S. dmesg is attached
Copyright (c) 1992-2008 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 7.0-RELEASE-p7 #0: Thu Dec 25 15:15:58 EST 2008
sullr...@freebsd7-releng_1_2_1.pfsense.org:/usr/obj.pfSense/usr/src/sys/pfSense_wrap.7
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: Geode(TM) Integrated Processor by AMD PCS (499.91-MHz 586-class CPU)
Origin = "AuthenticAMD" Id = 0x5a2 Stepping = 2
Features=0x88a93d<FPU,DE,PSE,TSC,MSR,CX8,SEP,PGE,CMOV,CLFLUSH,MMX>
AMD Features=0xc0400000<MMX+,3DNow!+,3DNow!>
real memory = 536870912 (512 MB)
avail memory = 515686400 (491 MB)
wlan: mac acl policy registered
K6-family MTRR support enabled (2 registers)
ath_hal: 0.9.20.3 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413, RF5413)
cryptosoft0: <software crypto> on motherboard
cpu0 on motherboard
pcib0: <Host to PCI bridge> pcibus 0 on motherboard
pci0: <PCI bus> on pcib0
Geode LX: Soekris net5501 comBIOS ver. 1.33 20070103 Copyright (C) 2000-2007
MFGPT bar: f00100006200
pci0: <encrypt/decrypt, entertainment crypto> at device 1.2 (no driver attached)
vr0: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe100-0xe1ff mem
0xa0004000-0xa00040ff irq 11 at device 6.0 on pci0
vr0: Quirks: 0x6
vr0: Revision: 0x96
miibus0: <MII bus> on vr0
ukphy0: <Generic IEEE 802.3u media interface> PHY 1 on miibus0
ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
vr0: Ethernet address: 00:00:24:cb:a2:3c
vr0: [ITHREAD]
vr1: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe200-0xe2ff mem
0xa0004100-0xa00041ff irq 5 at device 7.0 on pci0
vr1: Quirks: 0x6
vr1: Revision: 0x96
miibus1: <MII bus> on vr1
ukphy1: <Generic IEEE 802.3u media interface> PHY 1 on miibus1
ukphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
vr1: Ethernet address: 00:00:24:cb:a2:3d
vr1: [ITHREAD]
vr2: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe300-0xe3ff mem
0xa0004200-0xa00042ff irq 9 at device 8.0 on pci0
vr2: Quirks: 0x6
vr2: Revision: 0x96
miibus2: <MII bus> on vr2
ukphy2: <Generic IEEE 802.3u media interface> PHY 1 on miibus2
ukphy2: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
vr2: Ethernet address: 00:00:24:cb:a2:3e
vr2: [ITHREAD]
vr3: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe400-0xe4ff mem
0xa0004300-0xa00043ff irq 12 at device 9.0 on pci0
vr3: Quirks: 0x6
vr3: Revision: 0x96
miibus3: <MII bus> on vr3
ukphy3: <Generic IEEE 802.3u media interface> PHY 1 on miibus3
ukphy3: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
vr3: Ethernet address: 00:00:24:cb:a2:3f
vr3: [ITHREAD]
isab0: <PCI-ISA bridge> at device 20.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <AMD CS5536 UDMA100 controller> port
0x1f0-0x1f7,0x3f6,0x170-0x177,0x376,0xe000-0xe00f at device 20.2 on pci0
ata0: <ATA channel 0> on atapci0
ata0: [ITHREAD]
ata1: <ATA channel 1> on atapci0
ata1: [ITHREAD]
ohci0: <OHCI (generic) USB controller> mem 0xa0005000-0xa0005fff irq 15 at
device 21.0 on pci0
ohci0: [GIANT-LOCKED]
ohci0: [ITHREAD]
usb0: OHCI version 1.0, legacy support
usb0: <OHCI (generic) USB controller> on ohci0
usb0: USB revision 1.0
uhub0: <AMD OHCI root hub, class 9/0, rev 1.00/1.00, addr 1> on usb0
uhub0: 4 ports with 4 removable, self powered
ehci0: <EHCI (generic) USB 2.0 controller> mem 0xa0006000-0xa0006fff irq 15 at
device 21.1 on pci0
ehci0: [GIANT-LOCKED]
ehci0: [ITHREAD]
usb1: EHCI version 1.0
usb1: companion controller, 4 ports each: usb0
usb1: <EHCI (generic) USB 2.0 controller> on ehci0
usb1: USB revision 2.0
uhub1: <AMD EHCI root hub, class 9/0, rev 2.00/1.00, addr 1> on usb1
uhub1: 4 ports with 4 removable, self powered
orm0: <ISA Option ROM> at iomem 0xc8000-0xd27ff pnpid ORM0000 on isa0
ppc0: parallel port not found.
sio0 at port 0x3f8-0x3ff irq 4 flags 0x30 on isa0
sio0: type 16550A, console
sio0: [FILTER]
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
sio1: [FILTER]
Timecounter "TSC" frequency 499905667 Hz quality 800
Timecounters tick every 10.000 msec
Fast IPsec: Initialized Security Association Processing.
ad0: 1953MB <SanDisk SDCFX3-2048 HDX 4.32> at ata0-master PIO4
GEOM_LABEL: Label for provider ad0a is ufs/pfSense.
GEOM_LABEL: Label for provider ad0d is ufs/pfSenseCfg.
Trying to mount root from ufs:/dev/ufs/pfSense
Invalid time in clock: check and reset the date!
vr0: link state changed to UP
vr1: link state changed to UP
vr2: link state changed to DOWN
vr3: link state changed to DOWN
pflog0: promiscuous mode enabled
vr0: link state changed to DOWN
vr1: link state changed to DOWN
vr1: link state changed to UP
_______________________________________________
Soekris-tech mailing list
[email protected]
http://lists.soekris.com/mailman/listinfo/soekris-tech
