Some of questions on the Net6501:
1. Can the reset button be read by software or is hard wired as a
reset? (What I am trying to accomplish is a button to tell my own
software to restore itself to its unconfigured state.)
2. In the manual (Sept 19, vers 0.10) section 4.14 - JP8 - I see the
mark on the board for Pin1. But is Pin 2 the pin next to it in the same
row or the pin across from Pin1 in the other row?
In other words are the pins
1 2 3 4 5 6 7 8 ...
14 15 16 17 18 19 20 21 ...
--or--
1 3 5 7 9 ...
2 4 6 8 10 ..
3. I'm running a Linux kernel and when I tell it to reboot it gets back
to the bios but it only gets to this on the serial port and then stops:
POST: 012345
If I hit the reset button then things start over and run through the
boot-up sequence.
(I am running Bios "comBIOS ver. 1.40a 20110906")
Thanks,
--karl--
Karl Auerbach
InterWorking Labs, Scotts Valley, California
_______________________________________________
Soekris-tech mailing list
[email protected]
http://lists.soekris.com/mailman/listinfo/soekris-tech
