Dave wrote: > Martin Wache wrote: > >> Torgeir Veimo schrieb: >> >> >>> Dave wrote: >>> >>> >>>> Here is the actual log entry: >>>> >>>> Jul 17 22:33:32 vdr vdr: [8262] [softdevice-audio] Rate 24000 Hz is not >>>> possible (and using instead 48000 Hz is not implemented) FATAL exiting >>>> >>>> This drives me nuts! >>>> >>>> >>> Did you try changing the exit(1); in line 335 in audio-alsa.c to return 0; ? >>> >>> It's probably not enough, but not having a stream to check with makes it >>> a bit difficult to test. Can you make a recording where the audio >>> changes from 48000 to 24000 and upload it somewhere? >>> >>> >>> >>> >> I changed audio-alsa not to exit if the hardware is not able to audio >> format. Please report it if there are problems. >> >> Bye, >> Martin >> _______________________________________________ >> Softdevice-devel mailing list >> [EMAIL PROTECTED] >> http://bat.berlios.de/mailman/listinfo/softdevice-devel >> >> >> > Thanks! I will give it a shot! > > _______________________________________________ > Softdevice-devel mailing list > [EMAIL PROTECTED] > http://bat.berlios.de/mailman/listinfo/softdevice-devel > >
Ok I have tried this out, and its saved many recordings for me, I see the logs "NO AUDIO!" now. Not to be pushy, but is there a way to peek back at the audio stream to see if its cleared up? (back to 48000 hz, good signal), and re-establish audio output? The only way for me to re-establish audio output is to restart vdr. Switching channels doesnt help. Thanks for any reply! _______________________________________________ Softdevice-devel mailing list [EMAIL PROTECTED] http://bat.berlios.de/mailman/listinfo/softdevice-devel
