Thank you Fabricio :)
Le 22/07/2013 15:34, Fabricio Chamon a écrit :
"Don't ask me "why", but if I add a TurbulizeStrand (with very tiny
strengh (0,001)) after the Strand creation, it all goes well and the
polymesh gets generated."
Probably because the first strand position is aligned exaclty on top
of the particle position, then it cannot calculate the tangent vector.
The turbulize node shifts the two vectors a bit, and the tangent
calculation is then validated.
2013/7/19 olivier jeannel <[email protected]
<mailto:[email protected]>>
I found a little disfunction when using the stCreateStrandset of
compounds.
Sometimes, if you're creating strands a bit differently than the
usual way (EmitFromGeometry + CreateStrand) it can happen that the
generated polymesh contains 0 (zero) polygon.
(It happen to me when emitting from curve (indstead of point) and
also when emission was set to TotalNumberOfParticle, and other
exotic cases that I can't remember )
Don't ask me "why", but if I add a TurbulizeStrand (with very tiny
strengh (0,001)) after the Strand creation, it all goes well and
the polymesh gets generated.
Le 12/07/2013 17:15, Emilio Hernandez a écrit :
Thanks for this one Olivier!
I wish I had more time to get more into ICE...
2013/7/12 Malcolm Zaloon <[email protected]
<mailto:[email protected]>>
Perfect! And fast! Thanks for the tip Olivier!
On Thu, Jul 11, 2013 at 8:02 PM, olivier jeannel
<[email protected] <mailto:[email protected]>> wrote:
https://vimeo.com/64505408
Worth a try
Le 11/07/2013 18:09, Malcolm Zaloon a écrit :
Hello Guys!
I´m seaching for mt strand extrude addon to work with
SI 2014, this does exist?
where can be downloaded?
Thanks in advance.
--
__________________
Malcolm Zaloon - Lighting TD - XSI Generalist
Quote:
"Everything can be interconnected and will update
according by interface"
--
__________________
Malcolm Zaloon - Lighting TD - XSI Generalist
Quote:
"Everything can be interconnected and will update according
by interface"
--
