have you tried to merge the scene in a clean one? Also, you could try to parent the ofending cloud to a null, and the try to branch delete that null. Or the same procedure but with a model instead.
On Thu, May 21, 2015 at 10:02 AM, Paul Griswold < [email protected]> wrote: > I finally had a chance to get back to my scene that was crashing every > time I saved. > > I've tried "save as" and still get the same crash. > > Today I went in and tried to figure out if one of the point clouds were > the problem. I managed to find one point cloud where, if I try to delete > it, Softimage crashes. If I try to freeze it, Softimage crashes. > > I tried opening that point cloud, deleting all the nodes but leaving the > root in tact & then doing a save-as, but still crashed. > > Might be time to go back to an older version of the scene and rebuild it. > > > - Paul > > Sent via Cloze <https://www.cloze.com?kme=m-referral> > > > On May 15, 2015, at 7:49 PM, Matt Lind <[email protected]> > wrote: > > I've run into similar issues when developing tools. Try doing a 'save > as...' instead of 'save'. > > Matt > > > > > > Date: Fri, 15 May 2015 12:55:58 -0400 > From: "Paul Griswold" <[email protected]> > Subject: Re: particles save - crash > To: [email protected] > > Probably true - Process Monitor to the rescue! > > I just tried going in, disabling all ICE trees as well as hiding them, and > still ran in to the same issue - the moment it got to Saving Particles, > crash. > > The drive has 2 TB free and I can't find any write protected directories, > so > I'm not sure what the issue is. > > On May 15, 2015, at 12:48 PM, Stephen Blair > <[email protected]> wrote: This sounds like a case for > Process > Monitor... > > but I always say that > > On Fri, May 15, 2015 at 12:00 PM, Paul Griswold > <[[email protected]](mailto: > [email protected])> > wrote: > > I'm having a weird problem with a scene today.? When I try to save, it > gets > down to "saving particles" and then crashes. > > When I check the debug info, it says XSI didn't have the appropriate > access > to write to a directory, but it doesn't say what directory.? I've checked > every directory I could think of and couldn't find any permission issues. > > I've already done the typical runonce.bat, but I haven't delet > > > >
