This can typically happen when a plugin / command sets undo level to 0 and doesn't set it back to the previous value. Check any plugins you're using and narrow down until you figure out which one it is.
-------------------------------------------- Eric Thivierge http://www.ethivierge.com On Fri, Mar 18, 2016 at 10:54 AM, Tim Bolland <tim_boll...@hotmail.co.uk> wrote: > This has happened to me before once or twice. By any chance do you have > Fabric Engine installed? I don't know if there is any link, but I only > remembered this happening when I was playing around with Fabric. I'm > running 2015 SP2. > > Regards, > > Tim > > > ------------------------------ > From: adrian.w...@fluid-pictures.com > To: softimage@listproc.autodesk.com > Subject: 0 undo levels > Date: Fri, 18 Mar 2016 14:49:59 +0000 > > > we have a random issue where occasionally a session will start with undo > levels set to zero > > > > anyone seen this, and more importantly, stopped it from happening!? > > > > 2015 x64 > > > > a > > > > Adrian Wyer > Fluid Pictures > 75-77 Margaret St. > London > W1W 8SY > ++44(0) 207 580 0829 > > > adrian.w...@fluid-pictures.com > > www.fluid-pictures.com > > > > Fluid Pictures Limited is registered in England and Wales. > Company number:5657815 > VAT number: 872 6893 71 > > > > ------ Softimage Mailing List. To unsubscribe, send a mail to > softimage-requ...@listproc.autodesk.com with "unsubscribe" in the > subject, and reply to confirm. > > ------ > Softimage Mailing List. > To unsubscribe, send a mail to softimage-requ...@listproc.autodesk.com > with "unsubscribe" in the subject, and reply to confirm. >
------ Softimage Mailing List. To unsubscribe, send a mail to softimage-requ...@listproc.autodesk.com with "unsubscribe" in the subject, and reply to confirm.