Cool - thanks Mathieu and Adrian. Good tips, just what I needed. Best Morten
> Den 14. december 2016 klokken 17:22 skrev Mathieu Leclaire > <mlecl...@hybride.com>: > > > Just delete particle where the angle between the emit location normal > and the Y axis is greater then your desired threshold : > > > > On 14/12/2016 11:09 AM, adrian wyer wrote: > > just add a weight map, set it to linear Y, base weight 1, offset the > > reference position Y slider? > > > > a > > > > Adrian Wyer > > Fluid Pictures > > 75-77 Margaret St. > > London > > W1W 8SY > > ++44(0) 207 580 0829 > > > > > > adrian.w...@fluid-pictures.com > > > > www.fluid-pictures.com > > > > > > > > Fluid Pictures Limited is registered in England and Wales. > > Company number:5657815 > > VAT number: 872 6893 71 > > > > -----Original Message----- > > From: softimage-boun...@listproc.autodesk.com > > [mailto:softimage-boun...@listproc.autodesk.com] On Behalf Of Morten > > Bartholdy > > Sent: 14 December 2016 15:47 > > To: Userlist, Softimage > > Subject: ICE strands generation for Conifers > > > > I am looking at generating a Spruce tree using T-Gen or SpeedTree for the > > geometry and the generate the needles using Strands. To that end I would > > like to generate the strands growing from the top and sides af each > > twig/branch but not the underside. My question is if there is a way to > > isolate either of these areas in ICE or otherwise and perhaps generate a > > cluster or weightmap I can use in ICE? > > > > The only way I have found so far is to select Y+ in the Texture Editor which > > gives me samples of the area I want. How do I select vertices or polygons > > from this? Also is there a quicker way to select this area directly in ICE? > > > > Thanks. > > > > > > Morten > > ------ > > Softimage Mailing List. > > To unsubscribe, send a mail to softimage-requ...@listproc.autodesk.com with > > "unsubscribe" in the subject, and reply to confirm. > > > > ------ > > Softimage Mailing List. > > To unsubscribe, send a mail to softimage-requ...@listproc.autodesk.com with > > "unsubscribe" in the subject, and reply to confirm. > > > > > > ------ > Softimage Mailing List. > To unsubscribe, send a mail to softimage-requ...@listproc.autodesk.com with > "unsubscribe" in the subject, and reply to confirm. ------ Softimage Mailing List. To unsubscribe, send a mail to softimage-requ...@listproc.autodesk.com with "unsubscribe" in the subject, and reply to confirm.