The OBP version is: OBP 3.10.25 2000/01/17 21:26. I am quite certain it didn't change. I didn't install the power management packages when first installing Solaris 9. This was when the problem first became apparent. I then performed another initial install with the power management packages selected. This didn't yield any positive results.
Unfortunately for me the warranty has since long gone. I left a message on forum.sun.com & unfortunately (again) not much progress has come from it at all. I am totally lost to what the problem is. The only thing I haven't tried is the LOM packages on the Supplement CD. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Peter Kirkov Sent: Thursday, 3 July 2003 12:03 AM To: Solaris-Users mailing list Subject: Re: [Solaris-Users] netra t1 with solaris 9 fresh install on/standbyswitch Hello Brad, may be the best way is to open a case in Sun Online Service center, if your system is under warranty. Anyway: What packages are installed on system regarding LOM ? What is OBP version ? Did it change after installing Sol 9 ? Did you install power management packages ? Peter Wednesday, July 2, 2003, 4:40:50 PM, you wrote: Brad Case> Hi all, Brad Case> I recently installed solaris 9 onto my Netra 105 box. For the likes off Brad Case> me I can't figure out why the on/standby switch simply does not work Brad Case> since reinstalling. No matter what method I use, the box simply will Brad Case> not go into standby mode. Brad Case> I have tried powering the box down with the switch. I have tried Brad Case> executing the poweroff command in Solaris as well as shutdown -I 15 -g Brad Case> 0 -y . I have tried the power-off command at the PROM (ok) prompt. I Brad Case> have also tried placing the box into standby mode whilst in LOM mode by Brad Case> executing the poweroff command there. None off these methods work. The Brad Case> box just continually hums away :-(. Brad Case> I know this seems like I relatively dumb problem. And though I am new Brad Case> to Solaris, I am moderately ok with Red Hat. I've asked a few friends Brad Case> who are reasonably fluent with Sparc boxes & they have no idea what is Brad Case> the cause off this problem is either. I don't believe it to be hardware Brad Case> related because prior to doing an initial install off solaris 9 from Brad Case> Solaris 8, Standby worked like it should. Brad Case> I suspect that the possible source off the problem is the lack off the Brad Case> LOM package that is supplied on the Solaris 9 supplement CD. Brad Case> Unfortunately I do not have the supplement cd to either confirm or deny Brad Case> this being the problem. Brad Case> Any help with this would be very much appreciated. Brad Case> Thanks in advance. -- Peter Kirkov Support Engineer ________________________________________________ ACT Sofia Tzarigradsko shosse blvd. 7km BIC-IZOT, Office 710-714 Tel: +359-2-9718354 1113 Sofia - Bulgaria Fax: +359-2-9718343 mobile: +359-89-919638 mailto:[EMAIL PROTECTED] _______________________________________________ Solaris-Users mailing list [EMAIL PROTECTED] http://www.filibeto.org/mailman/listinfo/solaris-users _______________________________________________ Solaris-Users mailing list [EMAIL PROTECTED] http://www.filibeto.org/mailman/listinfo/solaris-users
