hello Dan, have you tried resetting the OBP variables to their defaults? you can try while at the ok prompt to do: set-defaults reset-all here is a link to the LOM users guide: http://www.filibeto.org/products-n-solutions/hardware/docs/pdf/806-2038-10.pdf
hope this helps. Stoyan ----- Original Message ----- From: "Dan O'Callaghan" <[EMAIL PROTECTED]> To: "Solaris-Users (E-mail)" <[EMAIL PROTECTED]> Sent: Monday, January 26, 2004 6:43 PM Subject: [Solaris-Users] Console acces on Netra T1 > Hi > > I've been given 2 Netra T1s to build. > > I'm having problems with the output of the console connection (LOM-A > port). > I can access the LOM without any problems with a standard "tip -9600 > /dev/ttya" on an E250. > Once i'm on the LOM all output is correct to the tip session is correct. > > As soon as i enter the "console" from withinn the LOM and type boot, the > screen output goes all over the place, as if the terminal session was the > wrong type. > > Is there any specific terminal type or any LOM setting to correct this? > I'm using a "ddterm" on the E250 for the connection. > > Thanks in advance, > dan > > ########################################### > > This message has been scanned by F-Secure Anti-Virus for Microsoft > Exchange. > For more information, connect to http://www.F-Secure.com/ > > _______________________________________________ > Solaris-Users mailing list > [EMAIL PROTECTED] > http://www.filibeto.org/mailman/listinfo/solaris-users > > _______________________________________________ Solaris-Users mailing list [EMAIL PROTECTED] http://www.filibeto.org/mailman/listinfo/solaris-users
