Also remember to create access lists which, IMHO ,only works in firmware v.6.3.x.x onwards.
DMZ must be configured with NAT enabled. An alternative could be to use the "Terminate VPN at LAN and DMZ" option at the Advanced button on the VPN config page. /jesper -----Original Message----- From: John Tolmachoff [mailto:[EMAIL PROTECTED]] Sent: 30. september 2002 21:24 To: [EMAIL PROTECTED] Subject: [SonicWALL]- VPN to DMZ To allow a remote office access to the DMZ via a VPN tunnel, all I have to do is add the destination network addresses to the VPN configuration, correct? John Tolmachoff IT Manager, Network Engineer RelianceSoft, Inc. Fullerton, CA 92835 www.reliancesoft.com --- [This E-mail scanned for viruses by Declude/F-Prot AV] ======================================================================== =========================== To unsubscribe, send email to [EMAIL PROTECTED] In the body of the email put the following: unsubscribe sonicwall your_name The archive of this list is at http://www.mail-archive.com/sonicwall%40peake.com/ --- [This E-mail scanned for viruses by Declude/F-Prot AV] ==================================================================================================To unsubscribe, send email to [EMAIL PROTECTED] In the body of the email put the following: unsubscribe sonicwall your_name The archive of this list is at http://www.mail-archive.com/sonicwall%40peake.com/
