On 04/14/2013 08:54 AM, Nick Holland wrote:
On 04/13/13 21:01, Stuart Henderson wrote:
On 2013/04/14 01:27, Stuart Henderson wrote:
On 2013/04/13 16:50, Raymond Lillard wrote:
...
First problem is:
When I boot in step 3, all four disks appear in the roll call as expected
in dmesg, but when I try the command "disklabel sd3", rsd3 is not found.
The device nodes are normally created in the installer when needed,
I think this is to save inodes on the ramdisk.
yep.
OK, I got it.
[another message]
1: I zero the first 10MB of all four disks with dd
2: I power cycle the box and boot form a cdrom snapshot from April 10
3: I use disklabel check that all disks have only C partitions
I'm not sure offhand where softraid metadata are stored to suggest
how much needs blanking, but obviously this must be further into the
disk than the partition table, you probably just need to go a bit
further with blanking. When I'm doing this I normally don't specify
a count and just hit ^C after a few seconds...not exactly scientific
but works for me.
Man page softraid(4) gives an example that indicates zero'ing the
first megabyte is sufficient.
first megabyte of what? The man page is having you clear the first 1MB
of the assembled disk, not the raw disks. If your softraid partition is
not starting in the first 1MB of RAID partition, zeroing the disk itself
does nothing, as it misses the softraid metadata.
I disagree with the man page, which has you clearing 1MB of the
/assembled pseudo-disk/, I've had much better luck clearing 1MB (though
I usually use Stuart's "wait a moment and hit CTRL-C" process) of each
/RAID partition/ *before* assembling the disk. There may be some logic
to clearing the first bit of the disk AFTER creation, too, in that's
where a lot of important tidbits are stored, might be nice to have RAID
consistent data there.
OK. After a more careful reading of the man page, I see the physical
disks in the sample are IDE, hence the dd to rsd0c
Thank you for debugging me.
At this point all is well with two disks in the machine. Using 4 disks
not work and panics the box. I will post about that in a different message.
Ray
