Ultrasparc 143MHz, 128mb mem.
RedHat 6.01 installed no problem on this machine.
1) Sound won't work, the driver loads up (cs4231a) but sound doesn't
work...
2) Xwindows scrambles the lower inch or so of the display. It scrambles
enough of the screen that gnome/kde panels get clobbered if the panel is
at the bottom. (Using both Xsun and Xsun24).
Don Lafontaine
Here's my dmesg output:
---------------------------[cut]-------------------------------------------
PROMLIB: Sun IEEE Boot Prom 3.5.0 1997/01/06 17:59
Linux version 2.2.5-15 ([EMAIL PROTECTED]) (gcc version egcs-2.92.11
19980921 (gcc2 ss-980609 experimental)) #2 Tue Aug 31 22:07:20 EDT 1999
ARCH: SUN4U
Ethernet address: 08:00:20:82:4c:4c
Console: colour dummy device 80x25
Calibrating delay loop... 285.08 BogoMIPS
Memory: 126136k available (1640k kernel code, 2448k data, 152k init)
[fffff80000000000,fffff80013f54000]
POSIX conformance testing by UNIFIX
PCI: Probing for controllers.
PCI: No PCI bus detected
IOMMU(SBUS): IMPL[0] VERS[0] SYSIO mapped at fffff9fe00000000
IOMMU: Streaming Buffer IMPL[0] REV[0] ... ENABLED
sbus0: Clock 25.0 MHz
dma0: Revision 2
dma1: Revision 2
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
Starting kswapd v 1.5
Console: switching to colour frame buffer device 128x54
fb0: cgsix at 0000000020000000 TEC Rev 4 CPU sparc Rev b
Sparc Zilog8530 serial driver version 1.41
tty00 at 0xfffd8004 (irq = 12,7e8) is a Zilog8530
tty01 at 0xfffd8000 (irq = 12,7e8) is a Zilog8530
tty02 at 0xfffb0004 (irq = 12,7e8) is a Zilog8530
tty03 at 0xfffb0000 (irq = 12,7e8) is a Zilog8530
Sun TYPE 5 keyboard detected without keyclick
pty: 256 Unix98 ptys configured
Sun Mouse-Systems mouse driver version 1.00
audio0: cs4231a at fffff9ffdc000000 irq 13,7e4
RAM disk driver initialized: 16 RAM disks of 4096K size
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
md driver 0.90.0 MAX_MD_DEVS=256, MAX_REAL=12
raid5: using high-speed VIS checksum routine
qlogicisp : PCI not present
esp0: IRQ 3,7e0 SCSI ID 7 Clk 40MHz CCF=8 TOut 167 NCR53C9XF(espfast)
ESP: Total of 1 ESP hosts found, 1 actually in use.
scsi0 : Sparc ESP100A-FAST
scsi : 1 host.
Vendor: IBM Model: DORS32160SUN2.1G Rev: WA7A
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 0, lun 0
Vendor: SEAGATE Model: ST32155W SUN2.1G Rev: 8856
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sdb at scsi0, channel 0, id 1, lun 0
Vendor: TOSHIBA Model: XM-5401TASUN4XCD Rev: 1036
Type: CD-ROM ANSI SCSI revision: 02
Detected scsi CD-ROM sr0 at scsi0, channel 0, id 6, lun 0
scsi : detected 1 SCSI cdrom 2 SCSI disks total.
esp0: target 6 asynchronous
Uniform CDROM driver Revision: 2.54
esp0: target 0 [period 100ns offset 15 10.00MHz FAST SCSI-II]
SCSI device sda: hdwr sector= 512 bytes. Sectors= 4226725 [2063 MB] [2.1
GB]
esp0: target 1 [period 100ns offset 15 10.00MHz FAST SCSI-II]
SCSI device sdb: hdwr sector= 512 bytes. Sectors= 4197405 [2049 MB] [2.0
GB]
sunlance.c:v1.12 11/Mar/99 Miguel de Icaza ([EMAIL PROTECTED])
eth0: LANCE 08:00:20:82:4c:4c
eth0: using auto-carrier-detection.
Partition check:
sda: sda1 sda2 sda3
sdb: sdb1 sdb2 sdb3
md.c: sizeof(mdp_super_t) = 4104
VFS: Mounted root (ext2 filesystem) readonly.
Adding Swap: 50904k swap-space (priority -1)
Adding Swap: 50904k swap-space (priority -2)
sunmouse: Successfully adjusted to 9600 baud.
sunmouse: Successfully adjusted to 1200 baud.
-
To unsubscribe from this list: send the line "unsubscribe sparclinux" in
the body of the message to [EMAIL PROTECTED]
