Dear Eric. Thank you very much for your fast and helpful answer, now we at least have a new apporach to try. We will look further into setting up a RAM disk. And if Mr. Lam has any other ideas, we would be very delighted to hear them.
Best regard, Philip Eric Deutsch schrieb am Freitag, 3. Dezember 2021 um 19:54:11 UTC+1: > Hi Philip, while I am not completely certain, I don’t think SpectraST has > any options for multi-threaded execution in the library import/conversion > steps. I recall Henry saying in the past that these operations tend to be > I/O bound mostly so multi-threading wouldn’t help very much? Maybe that was > true when disks were slower than today. Since you have so much RAM, you > might consider setting up a RAM disk: > > https://en.wikipedia.org/wiki/List_of_RAM_drive_software > > to see if that speeds things up considerably? Maybe not for the reading so > much as the writing? Read from an SSD and write to the RAM disk? > > > > That may not help a lot, but it’s the only thing I can think of at the > moment. Maybe Henry has other ideas? > > > > Regards, > > Eric > > > > > > *From:* [email protected] <[email protected]> *On > Behalf Of *Philip Gerth > *Sent:* Thursday, December 2, 2021 7:09 AM > *To:* spctools-discuss <[email protected]> > *Subject:* [spctools-discuss] Set number of cores/threads/RAM in > SpectraST? > > > > Good evening, > > I am using SpectraST for creating a spectral library out of a 71 GB > msp.file, which lead to a very long remapping step. Like 4 days for 10 % > progress. The PC I am using has an available 350 GB RAM, but it only runs > with a fraction of the possible power ~ 10 GB. It also only uses 2 of 9 > available cores. > > I have seen that there are options for Comet and X!Tandem to increase the > processing speed, like “spectrum,threads, so My question is, are there any > ways to do the same for SpectraST? Or is there a specific limit for the > performance level for SpectraST? > > Thank you in advance > > -- > You received this message because you are subscribed to the Google Groups > "spctools-discuss" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To view this discussion on the web visit > https://groups.google.com/d/msgid/spctools-discuss/848867d7-705b-412c-a6a3-eae181ae31e5n%40googlegroups.com > > <https://groups.google.com/d/msgid/spctools-discuss/848867d7-705b-412c-a6a3-eae181ae31e5n%40googlegroups.com?utm_medium=email&utm_source=footer> > . > -- You received this message because you are subscribed to the Google Groups "spctools-discuss" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/spctools-discuss/d3efaf57-ee23-4152-8c44-33c151cda344n%40googlegroups.com.
