Hi, Yes I was able to setup a Jitter test in Spectrum however I wasn't administering the network equipment when trying to get the test setup correctly becasue we had problems at first as well.
The following was our biggest problem and after we figured it out the test worked. You have to go into the destination device you want to test to and enable IP SLA. Here is a link and the steps to enable the test on the detination test device. Configuring the IP SLAs Responder on the Destination Device Before configuring a UDP jitter operation on the source device, the IP SLAs Responder must be enabled on the target device (the operational target). The IP SLAs Responder is available only on Cisco IOS software-based devices. http://www.cisco.com/en/US/docs/ios/12_4/ip_sla/configuration/guide/hsjitter.html Perform this task to enable the IP SLAs Responder. SUMMARY STEPS 1. enable 2. configure terminal 3. ip sla monitor responder 4. exit Hope this helps! --- To unsubscribe from spectrum, send email to [email protected] with the body: unsubscribe spectrum [email protected]
