You might try disabling all of your SNAM filters expect a very basic one that listens for your alarm. I would then add all of you filters back and see if that stops your first filter. I know if pervious versions depending on how you build your filters one can take presence over another..etc
Hope this helps and good luck. Andy Stein Duke Medicine Network and System Management Technologies [email protected] Office (919) 681-2739 Mobile (919) 402-7627 "Pretorius, Vynita" <[email protected]> 03/31/2010 11:05 AM Please respond to "Pretorius, Vynita" <[email protected]> To "spectrum" <[email protected]> cc Subject [spectrum] creating an alarm which is not triggering Setscript Hi All I have a strange issue – I create an alarm via cli, the alarm appears but the setscript never gets the alarm. I have one sanm policy which allows major and critical only. My alarm is critical. It appears as if any / all alarms I create from the cli do not go to alarmrc Why?? Thanks Vynita Pretorius 082 856 0321 To read FirstRand Bank's Disclaimer for this email click on the following address or copy into your Internet browser: https://www.fnb.co.za/disclaimer.html If you are unable to access the Disclaimer, send a blank e-mail to [email protected] and we will send you a copy of the Disclaimer. --To unsubscribe from spectrum, send email to [email protected] with the body: unsubscribe spectrum [email protected] --- To unsubscribe from spectrum, send email to [email protected] with the body: unsubscribe spectrum [email protected]
